Thread: Bearing puller

Anyone recommendations for a bearing puller suitable for KTM headraces and wheel bearings?

18" length of 1" andle for head outer races.

Grinder and oxy torch for inner race.

Heat gun and 12" long 1/2" round bar for wheel bearings.

If you have time and inclination you could make something like thisImageUploadedByTapatalk1342462380.554685.jpg
Helps to have a bicycle mechanic mate with a press to refit head races squarely as well
99% of the time I'll use a length of 3/4" brass rod

always used a drift , preferably a brass one , but sometimes What kev recomends is needed . If not a press . Pullers don't have much to pull against with headraces and wheel bearings , but never failed to drive them out with drift and hammer