Thread: 690 clutch slave compatibility? (chain just broke current one)

The chain on my 690 enduro just snapped and took a critical chunk out of my clutch slave cylinder.

Will these fit? They look pretty much the same as the holed one on my 690.

It looks similar to other models available on ebay (ie this for a 450 and seems the same for a 85)


I've got a 200EXC sitting in the garage, a bit buried, but be ideal if I could nab the one off that as it needs a few other bits doing before I use it anyway.
Couldn't be bothered to dig it out after pushing the 690 back a couple of miles tonight!

The 690 part number fits alot of bikes, did the chain go through the stock sprocket cover?

Cheers, the 200 isn't listed unfortunately, but seems to give a lot of options.
It just took the edge off the protruding 'bulb' at the end of the channel. Did wonder about bodging with jb weld or similar, but asking for trouble on a clutch, especially with a decent chunk gone.

200 is not the same as above.

Cheers. There's a few on ebay that should fit.

Got one from an 85 and seems to work fine - unfortunately my 200 chain is one link too short and I'm broke now, so haven't had a chance to try it.