I need to shorten kickstand on my 2011 sixdays 300 due to dropping suspension 50mm, anyone know if the plug on the bottom of stand will go back in once I've cut required amount of stand off?
Thanks in advance...
before you cut it warm the ally stand up with oxy and the foot just pops out as the plastic melts and pressure increases , ill measure how deep the hole is on my old one tomo for you
Back on an RFS again :)
Cut it off, punch the plastic foot out the bit you cut off, hammer it into the stand.
Or buy the short stand that KTM make
47003023044 SIDE STAND CPL.105XC 16/19" £60.78 less 15%
Adventure: the pursuit of life. Daniel Roy Wiarda
Kev, how much shorter is it?
when i tried to do this i screwed it right up
had to buy a new stand anyway
the foot came out and went back in ok
but it just was not right after cutting
may have cut the wrong end off - doh
my bike is lowered 25mm and i cut off 15 mm off the stand.perfect.
Is this a direct replacement stand ( only shorter ) no mods needed? Also, how much shorter is it Kev?
Originally Posted by KevInYorks