KTM Owners Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
853 Posts
Discussion Starter · #4 ·
thanks Kev,

checked out the links, to buy the connector from the US with post isnt far off buying a ready made cable.

The post i saw was a guy who just put the connectors straight into the bike plug...

but the link gives me the pin nmbers i need.

thanks !
 

·
Premium Member
Joined
·
31,658 Posts
I bought mine from Europe, cant remember where, just googled the part number.

Proper cheap way is to get one off a Yamaha at a breakers ;)
 
  • Like
Reactions: fluff34567

·
Registered
Joined
·
531 Posts
Small warning:

I originally bought a USB/OBDII cable cheap on eBAY and I could not get the drivers to install, when I checked again on the TuneECU web site the OBDII cable must have the FTDI chip set and it only works with Tune ECU when you use the associated CDM (D2XX) ver. 2.06.00 drivers or higher. The cheap cables just have a standard USB driver chip and not the FTDI device.

Hope this helps
 

·
Registered
Joined
·
853 Posts
Discussion Starter · #8 ·
ok after looking around i have bought the OBD cable for €9, and adaptor for €8 and i will will put pins straight onto the cable ends and read the pin numbers as i install.

I am not buying a 6 pin plug because the part is about €4 but post is around €20 :wanker:
 

·
Registered
Joined
·
853 Posts
Discussion Starter · #11 ·
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top