KTM Owners Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
can anyone help me out with a workshop manual for my 1993 ktm 620 sx lc4 , wp model.

bottom end is knocking so need to get it stripped down.

thanks
 

·
Registered
Joined
·
547 Posts
i have what you need, but manual pdf is 10.7MB large
do me your email address and i can email it to you.
 

·
Registered
Joined
·
547 Posts
sent.
 

·
Registered
Joined
·
118 Posts
Hi Craigh I don't know if your interested I have a 97 KTM 620 ESG Lc4 bike that I no longer use and a knee op means I can no longer kick start it
I put a new crank ie new main con rod little end full gasket set less than 1500 kms ago
bad point: a very slight weep at the front left of cylinder this is just a few drops of oil on the floor after a ride
bike is on Spanish reg with full legal paperwork
might be good for you for parts ? looking for £600 if you are interested e mail me for pics [email protected] I am in the Portmadog area of North Wales
 
1 - 7 of 7 Posts
Top