KTM Owners Forum banner
  • Hey everyone! Enter your ride HERE to be a part of October's Bike of the Month Challenge!
1 - 11 of 11 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
hi ive had a 2011 250 xc for a while , ive just purchased a new loom for it but ended up buying an exc loom so I can road register it , I also bought a power parts uprated stator to run lights in night rides ,current stator wasn't fit to keep the lights on long .

anyhoo im a bit stuck fitting this loom as theres new plugs and wires all over the shop .
from the stator theres 2 yellow wires female spades and on the loom theres a white and a yellow male spade , is there a certain orientation or ?

also up front along with the loom theres a separate little loom im not sure if this is for an ignition barrel or ?

pics to follow
any help greatly appreciated
 

·
Registered
Joined
·
5 Posts
no ecu on these bikes its a cdi 2 stroke 250 xc , cdi sits on the frame under the seat
sorry your rite !!! and ok its the same as mine then !!!! ive found that the indicator wiring loom does plug into the main loom. also there mite be a plug for a map switch
 
1 - 11 of 11 Posts
Top