[newsh]

So just went out to change the springs and notice there's no hex for undoing the fork caps so I need a tool with pins on. Where do I get one? Just ring Gear4?

 

[factoryjerv]

kev in yorks will sort ya buddy

 

[afw38]

So just went out to change the springs and notice there's no hex for undoing the fork caps so I need a tool with pins on. Where do I get one? Just ring Gear4?

I made my own but you could buy one of these. Check that the pins are smaller than your fork caps irst.

 

[newsh]

Just found one from demon mx

 

[PaulJC]

Make sure it's in stock before ordering

Where abouts are you?

 

[newsh]

I'm near Dorking, Surrey

 

[frog]

You can get one in any good tool shop.

I think they are called an adjustable pin spanner, the sort of thing you use to take grinding dics off of angle grinders.

Mine is made by Silverline and only cost a couple of quid.

 

[newsh]

Top tip thanks

 

[PaulJC]

Must be adjustable though, normal grinder spanners wont fit

Your a bit far away to pop round and borrow my socket lol